Search by Substrate

Pet Bowl Sublimation Instructions

Varies by Method

Varies by Method

Varies by Method

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

CondeTV Video


Detailed Instructions

Substrate DB70-CH, DB73-CH
Temperature Varies by Method
Time (min:sec) Varies by Method
Pressure Varies by Method
Additional
Recommended Paper DyeTrans Multi-Purpose or TexPrint
Heat Press Instructions

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Secure transfer to the Pet Bowl using ProSpray.
2. Wrap the Pet Bowl with protective paper. Take care to smooth any and all wrinkles.
3. Secure the DYEWRAP07 around the Pet Bowl. Tighten DYEWRAP07 to finger tight, then give it two more turns using a common wrench.
4. Place into oven and set dwell time to time listed above.

Application notes: You may need to wet the back of the transfer with water to allow it to lay flat against the surface of the bowl. The protective sheet of paper for the large bowl should be 3.5" x 19".

Instructions for using SubliShrink and an oven.
400° 13-14 Minutes

1. Cut out design and secure transfer to the pet bowl using heat tape (item 54150). You may need to wet the back of the transfer with water to allow it to lay flat against the surface of the bowl.
2. Place in shrink bag (item SF135)
3. Use heat gun to shrink bag to pet bowl
4. Place into pre heated, 400° oven and set dwell time to 13-14 minutes.
6. Remove from oven
7. Remove shrink bag and image from tumbler
Application notes: When image begins to show though SubliShrink, your sublimation is complete.

Shrink Wrap Instructions 400° 14 Minutes

1. Cut out design and secure transfer to the pet bowl using heat tape (item 54150). You may need to wet the back of the transfer with water to allow it to lay flat against the surface of the bowl.
2. Place in shrink bag (item SF135)
3. Use heat gun to shrink bag to pet bowl
4. Place into pre heated oven and set dwell time to time listed above.
6. Remove from oven
7. Remove shrink bag and image from tumbler
Application notes: When image begins to show though SubliShrink, your sublimation is complete.

Pressure Cheat Sheet

Contact Level
PSI
Press Dial Level
Average Human Resistance Felt
Contact Pressure
10-15 psi
1 on press dial
where the platen just makes physical contact with product
Light Pressure
20 psi
2 on press dial
resistant with one arm pressing down, easy with two arms
Medium Pressure
40-60 psi
3-5 on press dial
resistant with two arms pressing down, doesn’t require usage of shoulders
Heavy Pressure
80 psi
6 and up on dial
very resistant with two arms pressing down, requires lifting of elbows and shoulders to lock in place
Report a Problem