OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
Substrate | FLP030, FLP029, FLP028, FLP027, FLP016, FLP015, FLP014, FLP013 |
---|---|
Temperature | 400°F (204°C) |
Prepress | 5 Seconds |
Time (min:sec) | :30 |
Pressure | Light |
Additional | PROSPRAY-II, Lint Roller |
Recommended Paper | DyeTrans Multi-Purpose or TexPrint |
Heat Press Instructions |
Hover transfer under open heat press for 10 seconds to dry excess moisture. 1. Cover the bottom table of the press with a sheet of protective paper.2. Lint roll the image area of the substrate. 2. Place substrate face up on bottom table, cover with protective paper, and pre-press for 5 seconds. 3. Secure transfer to substrate using ProSpray. 4. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table. 5. Top with protective paper and press according to time, temperature, and pressure above. Click here for a video on using the Flip Flop Assembly Tool Application notes: The Flip Flop Assembly Tool (FLP013) will work easier if you lubricate the tool on the outside of the clip-grip. We recommend any brand of Spray PTFE Dry Non-Staining Lubricant. Read the label and choose a lubricant without silicone. Sample brands available at your local hardware store include Blaster® or Elmers® E450 Slide-All. |