OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
Substrate | RFG93 |
---|---|
Temperature | 385°F (196°C) |
Prepress | 5-10 |
Time (min:sec) | :50 |
Pressure | Light |
Additional | Lint Roller |
Recommended Paper | DyeTrans Multi-Purpose or TexPrint |
Heat Press Instructions |
1. Cover the bottom table of the press with a sheet of protective paper. 2. Lint roll the image area of the substrate. 3. Place substrate face up on bottom table, cover with protective paper, and pre-press for 10 seconds. 4. Secure transfer to substrate using ProSpray. 5. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table. 6. Top with protective paper and press according to time, temperature, and pressure above. **Application notes: Hang the slim "hook" side of the Velcro with hooks facing up off of the heat press on first press, then hang thicker "loop" side face up off of heat press on second press. |