Heat Tape, PROSPRAY-II, Lint Roller
DyeTrans Multi-Purpose
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
1
MINUTE
15
SECONDS
385
DEGREES
LIGHT
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1. Cover the bottom table of the press with a sheet of protective paper.
2. Lint roll the image area of the substrate.
3. Secure transfer to substrate using ProSpray.
4. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table. Place entire closed notebook on heat platen.
5. Top with protective paper and press according to time, temperature, and pressure above.
Application note: Should substrate warp or buckle after pressing, weight the substrate while cooling. For double-sided items: Let cool completely, repeat steps 1-5 for second side.
Updated: December 10, 2019
