Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

DyeFlex Phone Case Insert Sublimation Instructions for 305888-K

Stacking Order:

HEAT PLATEN
PROTECTIVE PAPER
SUBSTRATE
TRANSFER
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Heat Tape

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

1
MINUTE

15
SECONDS

400
DEGREES

HEAVY
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

DyeFlex shrinks when pressed. If after pressing your insert is still too large to fit in the case, press for an additional 15 seconds.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Remove blue peel coat from the substrate.
3. Secure transfer to substrate using ProSpray or Heat Tape.
4. Place substrate face down, with attached transfer face up, on top of protective paper on bottom table.
5. Top with protective paper and press according to time, temperature, and pressure above.

Application notes: When using heat tape, cover the minimum area of the edge of the part to fasten it to the transfer. Too much extra, and you will see impressions of the tape on the imaged part. This is especially the case if you tape across the part instead of taping along a single edge.

Updated: April 8, 2019

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback