Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Ceramic 11oz Deco Mug Sublimation Instructions for DECO-MUGK

Required Accessories

Heat Tape

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

4
MINUTES

30
SECONDS

400
DEGREES

MEDIUM
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Secure transfer to the Ceramic Mug using Heat Tape.
2. Top with protective paper, taking care not to extend the paper well above or below the top and bottom of the mug.
3. Place Ceramic Mug in Mug Press and close the heating element around the mug.
4. Press at 400, for 4 mins and 30 sec, at medium pressure.
5. Remove any paper residue with a soft wet cloth or dish sponge.

Click here for an in-depth FAQ on Mug Pressing Techniques

Application notes: The typical imaging area for a mug is 1.25? in from the handle and .25? from the top and bottom sides of the mug.

Place heat tape on the transfer edges closest to the handle that does not have sublimation ink on it after you have aligned the image on the mug. Use heat tape to attach the transfer to the mug taking care not to cover any of the imaging area.

Use a fan to cool ceramic mugs or the A6000 Kool Plate. Do not dunk mugs in water.

Instructions for Using an Oven and DYEWRAP

1. Secure transfer to the Ceramic Mug using Heat Tape.
2. Wrap and secure DYEWRAP, over transfer, to the Ceramic Mug. Take care to ensure the transfer is not wrinkled under the wrap.
3. Place in 400° preheated oven for 15 minutes.
4. Remove mug from oven and immediately remove transfer and wrap and allow to cool under a fan.

Click here for our DYEWRAP Overview and Application Video

Updated: April 9, 2019

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback