Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

eReader Device Cover Inserts for DS043SS

Required Accessories

Heat Tape

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.


SECONDS

385
DEGREES

LIGHT
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

Remove peel coat from inserts.If bottom platen is cold, begin by preheating for 15 seconds.

1) Lay protective paper on heat press platen.

2) Remove protective film from insert.

3) Lay insert imaging side face-down on transfer. Use heat tape or Pro Spray to keep it in place.

4) Add a piece protective paper over your transfer and insert.

5) Press. Add 2-3 seconds for each additional insert imaged at the same time.

NOTE: When adding the insert to a phone case, before you remove the protective paper covering the pre-glued area, start at one side and smooth out any air that may be trapped under the glue strip. Then you may remove the paper and insert the newly decorated insert. This will make the insert more secure.

NOTE: If you should see a void in the provided glue layer, add a drop of Super Glue to those areas prior to assembly of the product.

Updated: April 29, 2015

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback