Heat Tape
DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
60
SECONDS
400
DEGREES
HEAVY
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1. Cover the bottom table of the press with a sheet of protective paper.
2. Wipe the SubliWrap with 70% Isopropyl Alcohol prior to pressing.
3. Secure transfer to substrate using Heat Tape or ProSpray.
4. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
5. Top with protective paper and press according to time, temperature, and pressure above.
Encourage your customers to save their backing sheet for later storage of their SubliWrap.
Application note: Using heat tape is not preferred. If you do try it, allow the substrate to cool completely before removing the taped transfer.
If the adhesive side of the SubliWRAP should become dirty, you can clean it with 70% Isopropyl Alcohol. When it dries it will regain it's stickiness.
Silhouette material setting: Silhouette Vinyl, blade setting 1, Speed 5, and thickness 10.
Updated: December 6, 2018