Heat Tape
DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
45
SECONDS
400
DEGREES
LIGHT
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1. Cover the bottom table of the press with a sheet of protective paper.
2. Secure transfer to substrate using ProSpray or Heat Tape.
3. Place substrate face down, with attached transfer face up, on top of protective paper on bottom table.
4. Top with protective paper and press according to time, temperature, and pressure above.
Some inserts have a slight jagged edge. Rubbing the edge across a flat sheet of paper on a hard surface will smooth it.
Clean the phone surface with Isoprophyl alcohol and let it dry before affixing the ring stand. Allow it to sit at least an hour before using.
Application notes: For attaching insert to Ring Stand, we recommend e6000 (sold separately under part number 230025) or Liquid Nails For Small Projects, Clear Silicon Adhesive. Beware that the set time is 6 hours and the cure time is 16 hours.
Updated: August 21, 2018