Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Ring Stand Phone Holder Sublimation Instructions for RS23

Stacking Order:

HEAT PLATEN
PROTECTIVE PAPER
SUBSTRATE
TRANSFER
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Heat Tape

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

45
SECONDS

400
DEGREES

LIGHT
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Secure transfer to substrate using ProSpray or Heat Tape.
3. Place substrate face down, with attached transfer face up, on top of protective paper on bottom table.
4. Top with protective paper and press according to time, temperature, and pressure above.

Some inserts have a slight jagged edge. Rubbing the edge across a flat sheet of paper on a hard surface will smooth it.

Clean the phone surface with Isoprophyl alcohol and let it dry before affixing the ring stand. Allow it to sit at least an hour before using.

Application notes: For attaching insert to Ring Stand, we recommend e6000 (sold separately under part number 230025) or Liquid Nails For Small Projects, Clear Silicon Adhesive. Beware that the set time is 6 hours and the cure time is 16 hours.

Updated: August 21, 2018

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback