PROSPRAY-II, Lint Roller
DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
1
MINUTE
10
SECONDS
385
DEGREES
LIGHT
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
NOTE: The dimensional stability of the fleece fabric makes it very difficult to obtain exactly straight edges, so it is not suitable for full bleed, edge-to-edge printing that utilizes specific graphics.
Note: To press both sides, pre-press both sides first. Then press one side, allow to cool and then press the other side.
1) Cover the press with a protective paper sheet.
2) Place the baby blanket, imaging area of the blanket face up, transfer face down on the press and lint roll the entire area that will come into contact by the press. If blanket will not lay flat, use tape to hold down the corners, remove the tape after the pre-press irons it flat.
3) Pre-heat.
4) Sticky lint roll the baby blanket while warm and then remove from the press and allow cooling.
5) Lightly mist transfer with DyeTrans Pro Spray.
6) Place the transfer on the fabric, smooth wrinkles.
7) Cover with protective paper and press.
Prior to preheating, cover the entire imaging area of the blanket with a single piece of protective paper. The best way to accomplish this is to use uncoated newsprint or non-wax coated butcher paper*. If you do not have these products on hand, then use the largest possible piece of protective paper to cover the entire imaging area. After pre-heating, discard the blanket protective paper.
*Gordon Paper Co., Inc. White Tarpon Butcher Paper #661697 (available at Sam's Club)
Updated: December 20, 2018