DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
SECONDS
400
DEGREES
LIGHT
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
U6600 - 70 seconds
U5732, U5782-002, U9697 - 55 seconds
1) Place protective paper on the bottom of the press.
2) Remove the plastic peel coating from the metal, this is the imaging side.
3) Adhere the transfer to the metal using Pro Spray or heat tape.
4) Place the metal, imaging side face-down onto the transfer, on top of the protective paper. Add a sheet of protective paper on top. Press.
5) Remove the transfer from the metal quickly, be sure to take care as the metal will be hot.
Updated: April 29, 2015
