Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Bison Ceramic Tile Sublimation Instructions for CE8X10DS

Stacking Order:

HEAT PLATEN
GREEN PAD
PROTECTIVE PAPER
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
NOMEX FELT PAD
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Heat Tape, 1/8" Heat Conductive Green Rubber, 1/2" Nomex Felt

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

6
MINUTES

400
DEGREES

MEDIUM
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Place Nomex Felt Pad on Bottom Table.
2. Cover the Nomex Felt Pad with a sheet of protective paper.
3. Use Heat Tape to attach your transfer to the tile.
4. Place the tile with imaging side face up, with attached transfer face down, on top of Nomex Felt Pad and protective paper, on bottom table.
5. Cover with a sheet of protective paper.
6. Cover it all with a piece of 1/8" Heat Conductive Green Rubber Pad, and press according to time, temperature, and pressure above.

Application notes: Do not use grout for IronClad tiles, especially colored grout which will stain the tiles. Mortar, glue or silicone are recommended.

Updated: January 24, 2019

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback