Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Glass Cutting Board Sublimation Instructions for GCB001

Stacking Order:

HEAT PLATEN
PROTECTIVE PAPER
SUBSTRATE
TRANSFER
PROTECTIVE PAPER
NOMEX FELT PAD
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Heat Tape, Nomex Felt

Paper

TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

5
MINUTES

400
DEGREES

HEAVY
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. First place a sheet of protective paper on the bottom table.
2. Place the Nomex felt pad on top next.
3. Place another sheet of protective paper.
4. Affix the transfer to the substrate with either heat tape or Prospray.
5. Place substrate face down, so that transfer rests below the substrate.
6. Press at recommended time, temperature, and pressure.

Updated: July 26, 2018

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback