Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Gaming Cloth Holiday Stocking Sublimation Instructions for HS21

Stacking Order:

HEAT PLATEN
PROTECTIVE PAPER
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Heat Tape, Lint Roller

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

60
SECONDS

400
DEGREES

LIGHT
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

Production of this item is a 2-step process. You will transfer the top, then the bottom, in two separate pressings.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Lint roll the image area of the substrate.
3. Place substrate face up on bottom table, cover with protective paper, and pre-press for 20 seconds.
4. Secure transfer to substrate using ProSpray. You may press the top (cuff), or the bottom. Do not attempt to press both areas at the same time.
5. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
6. Top with protective paper and press according to time, temperature, and pressure above.

Repeat steps 1-6 to transfer the remaining area of the stocking.

Production of this item is a 2-step process. You will transfer the top, then the bottom, in two separate pressings.

Application notes: Watch the video tutorial for the exact procedure with regards to hanging the top off the press and separately pressing the bottom area of stockings.

Updated: August 31, 2018

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback