Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Scuba Foam Beverage Insulator Sublimation Instructions for HUG6U

Stacking Order:

HEAT PLATEN
PROTECTIVE PAPER
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

PROSPRAY-II, Lint Roller

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

50
SECONDS

385
DEGREES

LIGHT
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Sticky lint roll the image area of the substrate.
3. Secure transfer to substrate using ProSpray.
4. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
5. Top with protective paper and press according to time, temperature, and pressure above.

***Please see video on how to stitch unswen huggers Here

Updated: July 20, 2018

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback