Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

SubliSlate Sublimation Instructions for SUSL863

Stacking Order:

HEAT PLATEN
GREEN PAD
PROTECTIVE PAPER
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Heat Tape

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

11
MINUTES

400
DEGREES

MEDIUM
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Wrap your transfer around your slate and tape it to the back of the slate using heat tape.
3. Place substrate face up, with attached transfer face down, on top of protective paper, on bottom table.
4. Cover it with a piece of protective paper and 1/8" Heat Conductive Green Rubber Pad and press according to time, temperature, and pressure above.

Application notes: If you do not use a green pad, your transfer paper may stick to the Slate and it is difficult to remove. Once your green pad heats up, you might want to reduce press time by about 30 seconds. Cleaning the slate before pressing is recommended.

Laser Cutting:
35 watt laser at 70% power and 100% speed at 500ppi

Updated: December 30, 2018

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback