Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Unisub Aluminum Ornament Sublimation Instructions for U4335

Stacking Order:

HEAT PLATEN
PROTECTIVE PAPER
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Heat Tape

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

1
MINUTE

15
SECONDS

400
DEGREES

MEDIUM
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Secure transfer to substrate using ProSpray or Heat Tape.
3. Place substrate face down, with attached transfer face up, on top of protective paper on bottom table. You may print both sides at once; just insert the item between two printed transfers and press.
4. Top with protective paper and press according to time, temperature, and pressure above.

Application notes: Double-sided items: Let cool completely, repeat steps 1-4 for second side.

Do not stack items while hot. Place separately on a table to cool.

Updated: November 11, 2019

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback