Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Aluminum Sign Sublimation Instructions for U4340

Required Accessories

Heat Tape

Paper

DyeTrans Multi-Purpose

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

1
MINUTE

20
SECONDS

400
DEGREES

LIGHT
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1) Place protective paper on the bottom of the press.

2) Remove the plastic peel coating from the metal – this is the imaging side.

3) Adhere the transfer to the metal using DyeTrans Pro Spray or heat tape.

4) Place the substrate, imaging side face-down, transfer face-up, onto the protective paper covering the bottom of the press. Press.

6) Remove the transfer from the metal being sure not to touch the imaging area while hot.

Updated: June 24, 2016

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback