Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Cuff Bracelet Sublimation Instructions for U4644

Stacking Order:

HEAT PLATEN
PROTECTIVE PAPER
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Heat Tape

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

65
SECONDS

375
DEGREES

MEDIUM
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Secure transfer to substrate using ProSpray or Heat Tape.
3. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
4. Top with protective paper and press according to time, temperature, and pressure above.

After bracelet cools, protect with a piece of fabric and bend.

Application notes: We have found the bracelet bends better, and there is less chance of the coating breaking, when the bracelets are slightly warm when bent. Never bend ice cold cuffs.

For the best bracelet Do not bend the bracelets sharply. Bending sharply will cause the coating to crack. We recommend a small gradual bend and swapping sides to gradually bend the opposite side. Repeat until the bracelet has the proper shape.

Updated: August 6, 2019

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback