Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

UNISUB Aluminum Clipboard Sublimation Instructions for U9582

Stacking Order:

HEAT PLATEN
POLYPOPLIN FABRIC
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Heat Tape

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

1
MINUTE

30
SECONDS

400
DEGREES

MEDIUM
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Secure transfer to substrate using Heat Tape.
3. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
4. Cover it all with a piece of Poly Poplin Fabric (PP7813) and press according to time, temperature, and pressure above.
5. Allow the substrate to cool. Handling the panel while hot increases the chances of damaging the coating on the edges.

Click here for the flat clip assembly instructions.

Updated: September 6, 2018

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback