Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

ShoutBox Wall Art Sublimation Instructions for U9711

Stacking Order:

HEAT PLATEN
PROTECTIVE PAPER
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Heat Tape

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

1
MINUTE

15
SECONDS

400
DEGREES

MEDIUM
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Place substrate face up on bottom table, cover with protective paper, and pre-press for 20 seconds. Do not skip this step. After cooling, dry any remaining moisture on the hardboard.
3. Secure transfer to substrate using ProSpray or Heat Tape.
4. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
5. Top with protective paper and press according to time, temperature, and pressure above.

We recommend you use a quality glue to attach the ShoutBox panel to the frame. For best results, use e6000, sold separately. However, Gorilla® Glue or any epoxy will do just fine.

Application note: Should substrate warp or buckle after pressing, weight the substrate while cooling.

Updated: August 14, 2018

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback