Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Lanyard Sublimation Instructions for VSC01

Stacking Order:

HEAT PLATEN
PROTECTIVE PAPER
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

60
SECONDS

400
DEGREES

LIGHT
PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

You will also need 2 pieces of cardboard or aluminum (serving as lanyard backing material) cut to the size of the bottom heat press platen.

1. Place a sheet of protective paper.
2. Pre-Press the lanyard for 10 seconds, take off the press to cool.
3. Lightly mist the transfer with Pro Spray
4. Place a protective sheet of paper on a sheet of lanyard backer.
5. Place the transfer, imaging side face-up, onto protective sheet.
6. Align the lanyard, imaging side facedown, over the transfer and adhere. Note: if you are printing solid backgrounds, then an aggressive image bleed will be required as the lanyard expands when it is being pressed.
7. Place a protective sheet of paper over the lanyard then cover with a sheet of backing material sandwiching the transfer and lanyard material in between the 2 lanyard backers.
8. Holding the 2 sheets of backing material together, flip them so the transfer is now facedown onto the face-up imaging area of the lanyard.
9. Remove the top lanyard backer, place the bottom backer layer (with the transfer and lanyard material on top) onto the rubber heat press platen.
10. Gently remove the bottom backer and press.

Updated: February 14, 2020

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback