OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
Substrate | LMUG17SS |
---|---|
Temperature | Varies by Method |
Time (min:sec) | Varies by Method |
Pressure | Varies by Method |
Additional | Heat Tape |
Recommended Paper | Dye Trans or TexPrint |
Heat Press Instructions |
Hover transfer under open heat press for 10 seconds to dry excess moisture. Using the DK3T Heat Press:1. Wrap tumbler with transfer using heat tape (54150) to secure. 2. Insert in press. Cook for 4 minutes. 3. Remove from press. 4. Remove transfer. |
Shrink Wrap Instructions | Instructions for Using an Oven and SubliShrink 400° 6 minutes 1. Preheat oven to 400° 2. Cut out template and tape it tightly to your mug *Optional- if adding a handle design make sure that it is taped down securely. 3. Cut a slit about 2 inches from the bottom of the shrink wrap and slip the wrap over the mug with the handle out 4. Tape shrink wrap under handle to ensure that it will not separate when tightened with heat 5. Tuck excess SubliShink into the mug and evenly tighten the wrap by using the heat gun to apply hot air 6. Place in preheated oven for 6 minutes 7. Use caution to remove SubliShrink and paper from hot mug immediately 8. Allow mug to cool under a fan or using a Kool Plate® |