Heat Tape, PROSPRAY-II, Lint Roller
DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
60
SECONDS
400
DEGREES
MEDIUM
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1. Cover the bottom table of the press with a sheet of protective paper.
2. Lint roll the image area of the substrate.
3. Secure transfer to substrate using ProSpray or Heat Tape.
4. Protect spine and clasp of case by taping a strip of Teflon over both.
5. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
6. Hang case off edge of heat press to protect back half of case.
7. Top with protective paper and press according to time, temperature, and pressure above.
Application notes: Protect the leather portion of the case by keeping away from the heat. This can be done by using a piece of Nomex or Teflon.
Updated: February 17, 2020