Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Vapor Gaiter Sublimation Instructions for 7200-BL

Stacking Order:

HEAT PLATEN
PROTECTIVE PAPER
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Lint Roller

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

60
SECONDS

375

DEGREES

MEDIUM

PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom press platen with a protective paper sheet.
2. Place the Gaiter, imaging side face up, on the protective paper and lint roll thoroughly.
3. Place a piece of protective paper between the layers of the fabric to prevent the image bleeding through to the other side.
4. Prepress the fabric, let cool.
5. Lightly mist transfer with Pro Spray
6. Place the transfer on the fabric, smooth wrinkles.
7. Cover with protective paper.
8. Press with Temp/Time/Pressure settings listed above.

Application notes: If you are imaging the Gaiter full bleed, use two images and make a sandwich: protective paper, transfer, gaiter with paper inside, transfer, protective paper on top. Be sure to lint roll both sides after pre-press. Press with noted time, temp and pressure, then, flip the sandwich over and repeat the pressing.
Rotate the seam so that it is not on the edge of your sandwich to avoid press marks.

Updated: January 10, 2020

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback