PROSPRAY-II, Lint Roller
DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
50
SECONDS
400
DEGREES
HEAVY
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1. Cover the bottom table of the press with a sheet of protective paper.
2. Lint roll the image area of the substrate.
3. Place substrate face up on bottom table, positioned with the white panel on the press and the non-imaging half of the item over the side of the press. Ensure that none of the plastic parts inside the substrate are subjected to heat. Cover with protective paper, and pre-press for 10 seconds.
4. Secure transfer to substrate using ProSpray.
5. Place substrate face up on bottom table, positioned with the white panel on the press and the non-imaging half of the item over the side of the press. Ensure that none of the plastic parts inside the substrate are subjected to heat.
6. Top with protective paper and press according to time, temperature, and pressure above.
Updated: August 23, 2018