Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Pet Bowl Sublimation Instructions for DB70-CH

Required Accessories

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

15
MINUTES

400

DEGREES

MEDIUM

PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Secure transfer to the Pet Bowl using ProSpray.
2. Wrap the Pet Bowl with protective paper. Take care to smooth any and all wrinkles.
3. Secure the DYEWRAP07 around the Pet Bowl. Tighten DYEWRAP07 to finger tight, then give it two more turns using a common wrench.
4. Place into oven and set dwell time to time listed above.

Application notes: You may need to wet the back of the transfer with water to allow it to lay flat against the surface of the bowl. The protective sheet of paper for the large bowl should be 3.5" x 19".

Instructions for using SubliShrink and an oven.
400° 13-14 Minutes

1. Cut out design and secure transfer to the pet bowl using heat tape (item 54150). You may need to wet the back of the transfer with water to allow it to lay flat against the surface of the bowl.
2. Place in shrink bag (item SF135)
3. Use heat gun to shrink bag to pet bowl
4. Place into pre heated, 400° oven and set dwell time to 13-14 minutes.
6. Remove from oven
7. Remove shrink bag and image from tumbler
Application notes: When image begins to show though SubliShrink, your sublimation is complete.

400° 14 Minutes

1. Cut out design and secure transfer to the pet bowl using heat tape (item 54150). You may need to wet the back of the transfer with water to allow it to lay flat against the surface of the bowl.
2. Place in shrink bag (item SF135)
3. Use heat gun to shrink bag to pet bowl
4. Place into pre heated oven and set dwell time to time listed above.
6. Remove from oven
7. Remove shrink bag and image from tumbler
Application notes: When image begins to show though SubliShrink, your sublimation is complete.

Updated: December 18, 2018

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback