DyeFlex Card Sublimation Instructions for DFX0032W

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Remove blue peel coat from the substrate.
3. Secure transfer to substrate using ProSpray or Heat Tape.
4. Place substrate face down, with attached transfer face up, on top of protective paper on bottom table.
5. Top with protective paper and press according to time, temperature, and pressure above.

Application notes: When using heat tape, cover the minimum area of the edge of the part to fasten it to the transfer. Too much extra, and you will see impressions of the tape on the imaged part. This is especially the case if you tape across the part instead of taping along a single edge.

Updated: August 14, 2018