Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Aluminum Phone Inserts for IPC1212

Stacking Order:

HEAT PLATEN
PROTECTIVE PAPER
SUBSTRATE
TRANSFER
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Paper

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

1
MINUTE

15
SECONDS

370

DEGREES

LIGHT

PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Secure transfer to substrate using ProSpray or Heat Tape.
3. Place substrate face down, with attached transfer face up, on top of protective paper on bottom table.
4. Top with protective paper and press according to time, temperature, and pressure above.

*Application notes: too much pressure can cause a "cloudy" image.

Updated: August 19, 2020

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback