Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

PolyLinen Garden Flag Sublimation Instructions for JDW766

Required Accessories

PROSPRAY-II, Lint Roller

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

60
SECONDS

400

DEGREES

MEDIUM

PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Sticky lint roll the image area of the substrate.
3. Place a small strip of Teflon or metal in loop area of flag
4. Place substrate face up on bottom table, cover with protective paper, and pre-press for 30 seconds.
5. Secure transfer to substrate using ProSpray.
6. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
7. Top with protective paper and press according to time, temperature, and pressure above.
8. Remove Teflon strip and allow flag to cool

Washing instructions: Linen products are safe with machine washing in water temperatures below 122°F (50°C).

Updated: November 11, 2019

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback