Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Porcelain Ornament Sublimation Instructions for K102P-2

Stacking Order:

HEAT PLATEN
GREEN PAD
PROTECTIVE PAPER
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
NOMEX FELT PAD
BOTTOM TABLE

Required Accessories

PROSPRAY-II, Nomex Felt, Pressing Pad

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

3
MINUTES

30
SECONDS

400

DEGREES

LIGHT

PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Place 1/2" Nomex Felt Pad on Bottom Table.
2. Cover the Nomex Felt Pad with a sheet of protective paper.
3. Use ProSpray to attach your transfer to the ornament.
4. Place the ornament with imaging side face up, on top of Nomex Felt Pad and protective paper, on bottom table.
5. Cover with a sheet of protective paper.
6. Cover it all with a piece of 1/8" Green Rubber Pad and press according to time, temperature, and pressure above.

Updated: February 12, 2019

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback