Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Small Neoprene Instructions for MP070

Stacking Order:

HEAT PLATEN
PROTECTIVE PAPER
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

PROSPRAY-II, Lint Roller

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

60
SECONDS

400

DEGREES

LIGHT

PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Lint roll the image area of the substrate.
3. Place substrate face up on bottom table, cover with protective paper, and pre-press for 10 seconds.
4. Secure transfer to substrate using ProSpray.
5. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
6. Top with protective paper and press according to time, temperature, and pressure above.

Updated: December 21, 2018

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback