Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Mousepad Sublimation Instructions for MP527

Stacking Order:

HEAT PLATEN
PROTECTIVE PAPER
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

PROSPRAY-II, Lint Roller

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

60
SECONDS

400

DEGREES

LIGHT

PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Lint roll the image area of the substrate.
3. Secure transfer to substrate using ProSpray.
4. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
5. Top with protective paper and press according to time, temperature, and pressure above.


**If you are having ghosting issues, decrease the temp to 350° and increase press time to 1 minute and 40 seconds.

Updated: August 14, 2018

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback