Ceramic Camp Mug for MUG046

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Preheat oven to 400°
2. Cut out template and tape it tightly to your mug
*Optional- if adding a handle design make sure that it is taped down securely.
3. Cut a slit about 2 inches from the bottom of the shrink wrap and slip the wrap over the mug with the handle out
4. Tape shrink wrap under handle to ensure that it will not separate when tightened with heat
5. Either cut or tuck excess SubliShink into the mug and evenly tighten the wrap by using the heat gun to apply hot air
6. Place in preheated oven for 14 minutes
7. Use caution to remove SubliShrink and paper from hot mug immediately
8. Allow mug to cool under a fan or using a Kool Plate.

**These mugs will not fit into a standard mug press.**

Updated: June 30, 2021