Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Luma Steel Sublimation Stainless Steel Tumbler for MUG051

Required Accessories

Heat Tape, Green Pad, SubliShrink Wrap

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

4
MINUTES

375

DEGREES

LIGHT

PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

Instructions for Using a DK3D Mug Press

1. Secure transfer to the Tumbler using Heat Tape.
2. Cover with protective paper
3. Wrap the tumbler with heat conductive rubber (we recommend HCR-181010 for skinny tumblers)
4. Place Tumbler in Mug Press and close the heating element
5. Press at 375 degrees for 2 minutes
6. Rotate tumbler and press for an additional 2 minutes

Instructions for Using a DK3 Mug Press

1. Secure transfer to the Tumbler using Heat Tape.
2. Cover with protective paper
3. Wrap the tumbler with heat conductive rubber (we recommend HCR-18610 for skinny tumblers)
4. Place Tumbler in Mug Press and close the heating element
5. Press at 375 degrees for 2 minutes
6. Rotate tumbler and press for an additional 2 minutes

Instructions for Using an Oven and SubliShrink

1. Remove all plastic parts and lids
2. Cut out design and affix to tumbler using gold heat tape
3. Cover entire tumbler with blowout paper
4. Place in SubliShrink bag
5. Use heat gun to shrink bag to tumbler
6. Place in oven for 6 minutes at 360 degrees
7. Remove from oven
8. Remove shrink bag and image from tumbler

Updated: June 4, 2021

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback