Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

PolyLeather for NLP117

Stacking Order:

HEAT PLATEN
PROTECTIVE PAPER
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

50
SECONDS

375

DEGREES

MEDIUM

PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1.Cover the bottom table of the press with a sheet of protective paper.
2. Place blank product on bottom platen, cover with another sheet of protective paper and prepress for 10 seconds
3.Secure transfer to substrate using ProSpray, do not use tape.
4.Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
5.Top with protective paper and press according to time, temperature, and pressure above.

Application note: Should substrate warp or buckle after pressing, weight the substrate while cooling.

Updated: May 4, 2021

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback