PROSPRAY-II, Green Pad
DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
3
MINUTES
375
DEGREES
LIGHT
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1. Cover the bottom table of the press with a sheet of protective paper.
2. Use Pro Spray to attach your transfer to the substrate.
3. Place substrate face up, with attached transfer face down, on top of protective paper, on bottom table. You must imprint the 2-sided substrates twice. You cannot imprint both sides at the same time.
4. Cover it all with another piece of protective paper and 1/16" Heat Conductive Green Rubber Pad and press according to time, temperature, and pressure above.
Application notes: Double-sided items: Let cool completely, repeat steps 1-4 for second side. If using a 1/8” Heat Conductive Pad, add 1 minute to press time If imaging more than 6 at one time, please add 10-15 seconds per additional pendant.
Updated: January 27, 2020