PROSPRAY-II, Lint Roller
DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
1
MINUTE
20
SECONDS
385
DEGREES
HEAVY
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1. Cover the bottom table of the press with a sheet of protective paper.
2. Remove the Scarf from the Collar.
3. Sticky lint roll the image area of the substrate.
4. Place substrate face up on bottom table, cover with protective paper, and pre-press for 5 seconds.
5. Secure transfer to substrate using ProSpray.
6. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
7. Top with protective paper and press according to time, temperature, and pressure above.
Updated: March 20, 2019