DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
60
SECONDS
370
DEGREES
MEDIUM
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
SubliSocks production requires a sock jig (INSERT2H-01 or INSERT2S-01).
1. Cover the bottom table of the press with a sheet of protective paper.
2. Stretch the sock onto the jig. Smooth it so there are no bunched areas.
3. Secure transfer to substrate using ProSpray.
4. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table. You must imprint socks twice. You cannot imprint both sides at the same time.
5. Top with protective paper and press according to time, temperature, and pressure above.
Application notes: Socks decorated with the jig may show a white line on the jig edges. To help with that, it is suggested that when you do the second side, pull the material over the edges a little bit. Grasp the socks along the jig and slightly pull the already sublimated area forward so you can see the line of imprinting all along your jig. Doing the second side should fill the gaps. Experiment until you get the hang of it.
Click here for a complete tip-sheet from Vapor Apparel
Updated: November 20, 2018
