Skip to main content
Sublimation - Conde Systems - 27 Years Expert Experience
0 items in shopping cart

Textured Hardboard Panel Sublimation Instructions for U4825

Stacking Order:

HEAT PLATEN
POLYPOPLIN FABRIC
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
BOTTOM TABLE

Required Accessories

Heat Tape

Paper

DyeTrans Multi-Purpose or TexPrint

OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.

1
MINUTE

45
SECONDS

400

DEGREES

HEAVY

PRESSURE

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Secure transfer to substrate using ProSpray or Heat Tape.
3. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
4. Cover it all with a piece of Poly Poplin Fabric (F0008) or protective paper.
5. Press according to time, temperature, and pressure above.


Application note: Should substrate warp or buckle after pressing, weight the substrate while cooling.

Updated: August 9, 2019

© Copyright 2024 Condé Systems, Inc. All Rights Reserved.
About  |  Blog  |  Terms & Conditions  |  Privacy  |  Support  | Feedback