DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
2
MINUTES
30
SECONDS
400
DEGREES
LIGHT
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1) Pre-press the FRP for 20 seconds, allow to cool completely.
2) Dry transfer image under heat platen (just for a few seconds, do not lower it, just hover over the transfer paper.)
3) Cover the press with protective paper.
4) Lightly mist transfer with DyeTrans Pro Spray.
5) Place the transfer on the FRP, smooth wrinkles. Lay this face-up on the platen.
6) Cover with thin fabric (we recommend P/N# PCK45, sold separately)
7) Cover with protective paper.
8) Press with TIME/TEMP/PRESSURE settings listed above.
- Do not stack items while hot. Place separately on a table to cool. A thin plastic film that must be removed prior to pressing protects some items.
Click here for the Unisub Tip Sheet for cutting their substrates.
Click here for Fabrication Notes from a recent Unisub/Conde Webinar
Updated: August 16, 2016
