Heat Tape
DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
1
MINUTE
30
SECONDS
400
DEGREES
MEDIUM
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1. Cover the bottom table of the press with a sheet of protective paper.
2. Place substrate face up on bottom table, cover with protective paper, and pre-press for 20 seconds. Do not skip this step. After cooling, dry any remaining moisture on the substrate.
3. Secure transfer to substrate using ProSpray or Heat Tape.
4. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
5. Top with protective paper and press according to time, temperature, and pressure above.
Application note: During pressing, it is normal for trapped moisture to escape through the substrate’s edge foil. Should the edge foil come loose and flake off after transfer, this is indicative of an excessive amount of moisture within the substrate. In this instance, you will need to prepress (and cool) your substrates twice for 30 seconds each, prior to transfer. If the problem persists, contact Condé for replacement plaques.
Updated: August 17, 2018