Heat Tape
DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
1
MINUTE
15
SECONDS
400
DEGREES
MEDIUM
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1. Cover the bottom table of the press with a sheet of protective paper.
2. Secure transfers to substrate using ProSpray or Heat Tape, one on each side.
3. Place substrate face down, with transfer sandwich, on top of protective paper on bottom table.
4. Top with protective paper and press according to time, temperature, and pressure above.
Application notes: Allow the transferred substrate to sit and cool. Do not handle it hot, to reduce the chances of damaging the coating on the edges.
Curve the panel on a large round surface or use a Precision Roller.
Updated: August 30, 2018
