PROSPRAY-II, Lint Roller, Vapor Foam Kit
DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
60
SECONDS
380
DEGREES
HEAVY
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1) Cover the bottom press platen with a protective paper sheet to prevent bleed from image and/or shirt dyes.
2) Place the towel, imaging side face up, on the protective paper and lint roll the entire area that will come into contact by the press.
3) Hang the edges of the towel off the sides of the press if you can; if your image needs to be close to those edges, you may want to add Vapor Foam to push up the area near the hems so they do not make the press fall unevenly.
4) Lint roll and prepress the fabric, let cool.
5) Lightly mist transfer with DyeTrans Pro Spray.
6) Place the transfer on the fabric, smooth wrinkles.
7) Cover with protective paper. This paper must cover the entire area of the material that comes into contact with the heat platen.
8) Press with Temp/Time/Pressure settings listed above.
Updated: December 9, 2016
