Heat Tape
DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
1
MINUTE
15
SECONDS
400
DEGREES
MEDIUM
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1. Cover the bottom table of the press with a sheet of protective paper.
2. Secure transfer to substrate using ProSpray or Heat Tape.
3. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table. You may print both sides at once; just insert the item between two printed transfers and press. Always use Pro Spray when printing boths sides at the same time.
4. Top with protective paper and press according to time, temperature, and pressure above.
Updated: February 6, 2019