PROSPRAY-II, Lint Roller
DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
1
MINUTE
15
SECONDS
385
DEGREES
MEDIUM
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1. Cover the bottom table of the press with a sheet of protective paper.
2. Sticky lint roll the image area of the substrate.
3. Place substrate face up on bottom table, cover with protective paper, and pre-press for 10 seconds.
4. Secure transfer to substrate using ProSpray.
5. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
6. Press with Temp/Time/Pressure settings listed above.
***Application notes: For PFM60 & PFM61 imprint to the shiny white side and not the duller tan side.
Updated: March 9, 2020