Heat Tape
DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
11
MINUTES
400
DEGREES
MEDIUM
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1. Cover the bottom table of the press with a sheet of protective paper.
2. Wrap your transfer around your slate and tape it to the back of the slate using heat tape.
3. Place substrate face up, with attached transfer face down, on top of protective paper, on bottom table.
4. Cover it with a piece of protective paper and 1/8" Heat Conductive Green Rubber Pad and press according to time, temperature, and pressure above.
Application notes: If you do not use a green pad, your transfer paper may stick to the Slate and it is difficult to remove. Once your green pad heats up, you might want to reduce press time by about 30 seconds. Cleaning the slate before pressing is recommended.
Laser Cutting:
35 watt laser at 70% power and 100% speed at 500ppi
Updated: December 30, 2018