Heat Tape
DyeTrans Multi-Purpose
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
1
MINUTE
20
SECONDS
400
DEGREES
LIGHT
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
1) Place protective paper on the bottom of the press.
2) Remove the plastic peel coating from the metal – this is the imaging side.
3) Adhere the transfer to the metal using DyeTrans Pro Spray or heat tape.
4) Place the substrate, imaging side face-down, transfer face-up, onto the protective paper covering the bottom of the press. Press.
6) Remove the transfer from the metal being sure not to touch the imaging area while hot.
Updated: June 24, 2016
