ChromaLuxe Connections Murals Template Hanging System for U4709

Hover transfer under open heat press for 10 seconds to dry excess moisture.

Template Hanging System for ChromaLuxe Connections Murals

Needed:

Graph template
Sublimated Panels with attached Connections Hangers
Painter;s Tape
Drill and/or Screwdriver
No. 10 Pan or Round-Head Phillips Screws and Wall Anchors
Mallet or Hammer
Level - or Use the Compass Level phone app
Studfinder
Fasteners and equipment depends on weight of the images
Jig for metal mounts
Metal mounts
Adhesive-backed wooden blocks


1. With a sharpie or marking tool, mark the back of the product to ensure that you know it is right side up when applying mount
2. Align image with the groove on the jig
3. Follow the diagram on the back of the jig to know exactly where to apply the mount
4. Remove self-adhesive and stick mount onto specified area
5. Allow 24 hours for the adhesive on the mounts to fully cure

On larger images, wooden blocks can be adhered to the back to level it on the wall

Bigger pieces of aluminum will require 2 mounts

Step 1: Hang the Template
Using painter's tape, hand the template on the wall in the location where you will be putting your mural. Using a level, make sure it is straight.

Step 2: Drill Holes
Identify and mark the hole areas and drill them. These are "pilot" holes.

Step 3: Install Screws
Tap wall anchors into pilot holes. Install screws into wall anchors using drill or screwdriver.

Step 4: Hang Panels
Gently tear away the template paper. Starting at the bottom, hang each panel. You will hear a click as each mount fits over the screws.

Enjoy!


Here is the Unisub Tip Sheet: Mounting Option Chart

Updated: December 27, 2016